This article relies largely or entirely on a single source. (February 2019)
Bulgarian kaval in key of D (Re), African blackwood, made in 2012 by master craftsman Radoslav Paskalev
|Classification||Woodwind, Wind, Aerophone|
|Çığırtma, Dilli Kaval, Duduk, Flute, Frula, Kawala, Jedinka, Ney, Shvi, Sring|
Unlike the transverse flute, the kaval is fully open at both ends, and is played by blowing on the sharpened edge of one end. The kaval has eight playing holes (seven in front and one in the back for the thumb) and usually four more unfingered intonation holes near the bottom of the kaval. As a wooden rim-blown flute, kaval is similar to the kawala of the Arab world and ney of the Middle East.
A kaval made without joints is usually mounted on a wooden holder, which protects it from warping and helps keep the interior walls oiled. According to the key, the kaval can be in the high register (C, C#)???, middle (D, H) or low (A, B). The kaval plays two octaves and a fifth, in the chromatic scale. Its sound is warm, melancholic and pleasant.
The kaval is primarily associated with mountain shepherds throughout the Balkans and Anatolia and in the book Kaval: Traditional Folk Melodies for Balkan & Anatolian Folk Flute, musician Pat MacSwyney suggests that the kaval spread with the Yoruks from the Taurus mountains of southern Anatolia into the southern Balkans of southeast Europe.
While in the past it was almost entirely a shepherd's instrument, today it is widely used in folk songs and dances as part of ensembles or solo.
Unlike the transverse flute, the kaval is fully open at both ends, and is played by blowing on the sharpened edge of one end. The kaval has eight playing holes (seven in front and one in the back for the thumb) and usually four more near the bottom of the kaval. These holes are not used for playing the instrument, but determine the lowest tone's pitch and timbre and are supposed to improve tone and intonation. In Bulgaria they are known as "devil's holes", based on a folk tale in which the devil tries to out-play a shepherd in a musical duel. While the shepherd is sleeping, the devil drilled holes in the shepherd's kaval but instead of ruining the kaval, this only served to enhance the shepherd's kaval playing thus thwarting the devil. In North Macedonia they are known as "glasnici" (гласници) meaning "giving voice to/of".
When played, the kaval is held with both hands at an angle of approximately 45° from the body, with the four fingers of the one hand covering the lower holes; the upper three holes and the thumbhole are covered with the other hand. The mouth covers approximately three quarters of the end. Change of the breath air pressure also changes the pitch.
The kaval that is most common in Bulgaria is the one in middle (D) register. The kaval in lower (C) register is also not uncommon for this country. What is characteristic for the Bulgarian style of kaval performance is the incredible diversity of sound shades and techniques. According to the pitch there are four different registers that can be achieved with the Bulgarian kaval. What controls which register the performer works in is mostly the air flow and to some extent the position of the mouth and the lips on the end of the kaval. A very characteristic sound of kaval is achieved in the lowest register. It could sound very mild and gentle if blown lightly while by changing the air stream a deeper (flageolet like) sound is achieved. This sound is so outstanding that some consider it another register that they call - kaba. It is also very interesting to notice that the technique of circular breathing is successfully utilized while playing the kaval. This technique lets the performer play without interrupting the air flow, while taking a breath through the nose. In the past it has been considered an extraordinary skill while nowadays it is used by more and more young performers.
The Bulgarian kaval, once made of a single piece of wood, is now constructed of three separate sections (of cornel, walnut, plum or boxwood), with a total length of 60 to 90 cm. Bone rings cover the joints, to prevent the wood from cracking. Metal decoration is also found. The finger-holes are located in the central section, while the lower (shorter) section has four additional holes called dushnitsi or dyavolski dupki (‘devil’s holes’); these are not covered in performance.
In the south-west Rhodope mountains, two kavals in the same tuning (called chifte kavali) are played together, one performing the melody, the other a drone. This type of kaval is made from one piece of wood. A similar use of the kaval is also known in Macedonia and Kosovo, where one kaval of the pair (usually a lower one of a same key) is ‘male’, the other ‘female’.
In Turkey the term ‘kaval’ is used generally to refer to all shepherd’s pipes and more particularly (though not invariably) to ductless flutes. The presence or absence of a duct is sometimes specified by the addition of a qualification: dilsiz kaval (‘kaval without a tongue’), dilli kaval (‘kaval with a tongue’). Other qualifications may be added to describe materials, size or constructional features: kamiş kavalı (‘reed kaval’), çam kavalı (‘pine kaval’), madenı kavalı (‘metal kaval’); cura kavalı (‘small kaval’), çoban kavalı (‘shepherd’s kaval’, i.e. long kaval); üç parçalı kavalı (‘kaval with three parts’). The Turkish kaval can be made of wood, cane, bone or metal (usually brass) and has five or more finger-holes, one thumb-hole and sometimes additional unfingered holes like the Bulgarian instrument.
In Thrace and some of the Aegean Islands the term ‘kavali’ refers to an end-blown flute of the flogera family. It has seven finger-holes and sometimes an additional thumb-hole. In Greece's Macedonia the term kavali is also used to denote the souravli. In Epirus the end-blown kaval is known as dzhamara.
- najmal kaval (the smallest kaval) - length: 630 mm, basic tone: dis1;
- mal kaval (small kaval) - length: 672 mm, basic tone: d 1;
- kaval koj nema posebno ime (no-special-name kaval) - length: 700 mm, basic tone: cis 1;
- sreden kaval (middle kaval) - length: 752 mm, basic tone: c 1;
- golem kaval (the big kaval) - length: 785 mm, basic tone: h.
The smallest and the "no-name" kavals are the most used in North Macedonia's music tradition.
North Macedonia's šupelka is similar to the kaval (open on both ends), except that it is shorter (240–350 mm). It can be made of either walnut, barberry, ash wood, maple or other wood. The šupelka plays the chromatic scale (two octaves), except the first note of the lower octave. In the low register, its sound is soft and pleasant, while in the upper register it is sharp and shrill.
In Serbian music tradition, the kaval (cevara) is represented in Southern Serbia- in Kosovo, as well as in Southeastern and Eastern Serbia. Presentations of musicians on frescoes of medieval monasteries and churches of this side of the Balkans say that the kaval dates back to the medieval ages. On the side where it is being played, there is a sharp bird which enables the easier obtaining of the tone. The tone is got just when the kaval is being stuck to the lips semi-horizontally, or under the angle of 45 degrees, and the player blows straight.
The svirka (or tsafara, svorche, or little kaval) is a Bulgarian shepherds' flute, consisting of one wooden tube 25 to 50 cm long with six or seven holes for fingers, and a bone lip where it is endblown. It is played much like the kaval.
Bashkirs and Caucasus
A typical khobyrakh is a 70 cm-wide, smooth, hollow pipe made of an umbel (hollow stem of a big, parasol-like umbelifer) or wood, with 3 or sometimes 6 finger-holes. Nowadays, it is also made of plastic.
The Romanian caval dobrogean ("Dobrujan caval") or caval bulgăresc is a similar instrument to the Bulgarian kaval. The instrument known simply as caval, however, is instead a large duct flute. It has five finger-holes arranged in groups of two and three, counting from the distal end.
- Bob Snider's kaval page
- Jouer du kaval Bulgare: approche pratique à usage des débutants at blogspot (in French)
|Wikimedia Commons has media related to Kaval.|